AireRyder LK48614OR Manuel d'utilisation et d'entretien télécharger pdf

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK. BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1.Before installing, consult local electrical codes for wiring and grounding requirements.

2.The combined weight of your ceiling fan and light kit can not exceed 35 pounds unless

additional support is provided for the fan.

Installation Steps

Motor

Switch Box

Terminal(Groove)

Terminal(Tongue)

Switch Box cover

Light kit

Cap

Set Screw

Wire Nut

Lamp Plate

Nipple

Nipple-1

Pull Chain

Glass Shade

Rubber Washer

Hex Nut

Cap

Finial

Metal Washer

Wire Nut

Washer

Nipple-1

Cap Screw

Screw

Plug

Screw

Hex Nut

Fig.1

Fig.2

Hex Nut

Pull Chain for Fan

LK48614

1. Remove the switch box cover from the fan by loosing 3 screws.

2. Unscrew and discard the plug from the switch box cover.

3. Attach the light kit to the switch box cover.

***For fans of the Fig.1, please attach the nipple-1 of the light kit to the hole of the switch

box cover, and then thread the wires through the washer and hex nut, and secure tightly.

***

For fan as Fig.2: Unscrew the cap screw to remove the cap from the light kit, then

secure it upward to the switch box cover using the set screws (6x32 20mmL). Thread

the wires of the light kit through the cap and switch box cover. Attach the light kit to

the cap using the cap screw.

4. Make wire connections with the wire nuts:

---Connect black wire from light kit to blue wire from the fan.

---Connect white wire form light kit to white wire from the fan.

Carefully tuck wires back into the switch box cover.

5. Reinstall the switch box cover with the 3 screws.

6. Install bulbs.( Please do not exceed the maximum capacity which is recommended on the

package.)

7. Thread the pull chain through the glass shade, rubber washer, metal

washer and hex nut in order, and secure with the hex nut to the nipple.

8. Thread the pull chain through the cap and finial, and secure with the finial to the nipple.

9. Thread the pull chain of the fan through the glass shade and the cap.

*** Make sure the hole of glass shade and the hole of the cap for fan was match.

10. Turn on the power at fuse or circuit box.

070424

ASSEMBLY AND INSTALLATION 1

Résumé du contenu

Page 1 - ASSEMBLY AND INSTALLATION

ASSEMBLY AND INSTALLATION INSTRUCTIONSWARNING: TO AVOID RISK OF ELECTRICAL SHOCK. BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SE

Commentaires sur ces manuels

Pas de commentaire

AireRyder LK48614OR Manuel d'utilisation et d'entretien

Naviguer en ligne ou télécharger Manuel d'utilisation et d'entretien pour Accessoires de refroidissement du matériel AireRyder LK48614OR. AireRyder LK48614OR Use and Care Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels